10
Wireless Remote Controls: Programming
Wireless In-Dash & Hand-Held Remote Control Programming:
The camera is controlled with a programmable remote with different chan-
nels. This feature allows you freedom to change the channel selection, and
the receiver relearns the new selection.
Programming the transmitter
This camera has been pre-programmed at the factory, and is not necessary
to re-program the transmitter, unless you experience outside interference.
Important Note: Disconnect power by removing fuse or disconnecting vehicle
battery.
1. Remove battery cover from remote control.
2. Set the 7 dip switches to a selection of your choice. There are 3 positions
on each; positive, negative and neutral. Use a small screwdriver and se-
lect a position for each dip switch. Please note that the orientation of the
+/- switch positions may vary among different models of wireless remote
controls.
3. Make sure batteries are installed correctly and have adequate charge.
4. Replace battery cover.
5. Depress the on/off button and hold it down. Red LED will light.
6. While holding the on/off button down, reinstall the power.
7. Keep your finger on the on/off button for 5-6 seconds, and then release.
The camera should now be programmed.
Comments to this Manuals